On The Line Racing’s insanely trick 1994 CR125 is center stage on this week’s Two-Stroke Tuesday brought to you by Boyesen. We have new products in 2-Stroke Hardware from Hold It Wide, Flo Master and some staple items from R-Tech Plastics and PJ-1 oils. Don’t miss 2-Stroke Theater this week it features a couple project bikes with some 2018 hardware from Gas Gas and KTM. Honda CR250R faithful make sure you check out the exclusive link to our 2004 off-road rebuild.

This machine was the brainchild of Terry Good and was inspired by the works Suzukis piloted by Roger DeCoster in the early ’70s. At 167 lb. this just might be the lightest CR125R ever built and no one knows exactly how much it cost. Not even Terry.

Yep that’s a Mugen top-end and just about every fastener you see is titanium. Those aren’t carbon fiber graphics, the fenders, radiator shrouds, tank, airbox and number plates are actual carbon fiber. This saved another almost 9 pounds but was very, very expensive.

Not just anyone can build a bike like this. Many of the parts were HRC leftovers. Some parts, like the right-side-up forks weren’t even found on works bikes of the era. 911 MX Shop supplied loads of titanium that would ultimately lose 6.5 pounds compared OEM.

The pipe was hand-built by Don Emler himself at his Flying Machine Factory. Made with 47 cones out of special 22-gauge steel saving another 1.75 pounds. The four-inch long FMF silencer was loud but saved another half pound.

The man that inspired the build just happened to be on staff at Dirt Bike Magazine in 1994. Roger DeCoster is to this day still one of a very select group of people to ride this machine.

2-STROKE HARDWARE:

 HOLD IT WIDE FORM FITTING PRE-CUT TAPE

The Hold It Wide form fitting hand tape provides an extra layer of protection to stop blisters. It improves grip strength and feel which helps prevent arm pump and prevents blisters. Flexible and stretchy material makes it easy to apply and it does not bunch up like commonly used white medical tape

• Available in Thumb Only or Full Hand/thumb combo ( 1 pre-cut roll – 2″ x 16.4′ )
• Stops blisters
• Peel and Stick
• Flexible material for easy application and use
• Latex Free
• Water resistant
• Hypo-allergenic
• Used by top pros

Contact: www.holditwide.com

 FLO MASTER OIL CHANGE TUBE

R-TECH YZ125/250 REVOLUTION PLASTIC KIT

 

Update the look of your Yamaha YZ125/250 two-stroke all the way back to 2002 with the R-Tech Revolution plastics kit. Available in white, yellow and blue.

Contact: www.rtechmx.com

 

PJ1 GOLDFIRE PRO

PJ1 GOLDFIRE PRO 2-Stroke Racing Oil is designed for the serious racer who requires more efficient power for high revving greater horsepower 2-stroke engines. PJ1 uses only the highest grade of synthetics/petroleum oils with a special blend of additives to guard against piston scoring and cylinder wall scuffing as well as oxidation, and rust & corrosion. Provides less drag thereby improving throttle response, increasing power and allowing higher RPM.

APPLICATION AND PERFORMANCE:

• Designed for the serious racer.
• Greatly extends the life of pistons and rings.
• Lengthens engines life by improving lubrication at elevated temperatures.
• Extreme low coefficient of friction increases power and efficiency.
• Eliminates spark plug fouling, sticking power valves and carbon build-up.
• Protects against varnishing and sludge formation on critical engine parts.
• Inhibits rust, corrosion and oxidation.

Meets and exceeds all manufacturers warranty requirements.

Contact: www.pj1.com

2-STROKE THEATER:

2004 CR250R Off-Road Rebuild. CLICK THE IMAGE BELOW FOR THE FULL STORY !